Filter
Top Products
86 Chapter 4
C:\Spk\Ref\RefGuideRevE\Tools.fm
Overview of the Test Set’s Built-In Tools
Using the RF Tools Program
10. The trace of the device gain over the frequency range swept is
displayed. If the gain exceeds 40 dB, it will not appear on the trace.
The maximum gain is also displayed as text on the screen. To save
the plot to a PC card, press
k4
(Save Plot) and use the knob to enter
a filename. Press
k5
(Scr Dump) to send the image to a printer or to
the BTS Laptop Utility. Directions will appear at the top of the
screen. Press PRINT and allow the image to print to the connected
device. Then, press PAUSE/CONTINUE. Press
k1
(Proceed) when
you are ready to continue.
Figure 4-6 Example of a Swept Gain Plot Screen
11.The swept gain results screen (see Figure 4-7) appears with the test
results. If the BTS Laptop Utility is in use, this data is collected by
the laptop. If you wish to repeat the test using the same calibrated
devices and test parameters, press
k1
(Repeat). To re-display the plot
screen, press
k3
(Disp Plot). To return to the Select Test Menu,
press
k5
(Return).
Figure 4-7 Example of a Swept Gain Results Screen