Filter
Top Products
164 Chapter 5
C:\Spk\Ref\RefGuideRevE\CdmascrnE2.fm
CDMA Measurements - Screens and Control Fields
Control Fields for CDMA Measurements
Ofs Trnsfer
IS-95 only. This field transfers the time offset value from the time offset
measurement (displayed in TmOfs) to the Time Offset field
automatically. Before selecting Ofs Trnsfer, you must make at least
one of the following code domain measurements:
• Power
•Timing
•Phase
Operating Considerations
When using this command programmatically, be sure a value for Tm
Ofs has been obtained from a power, timing, or phase measurement.
(One method of ensuring the measurement has been completed would
be to send an GPIB command to query the results of the Tm Ofs field
before sending the transfer command).
Screens on which this field is present
COD DOM (Code Domain Analyzer): FP setup controls menu
Output Port
This field selects the output port for the signal from the Test Set’s RF
and CDMA generators.
RF Out selects the RF IN/OUT connector.
Dupl selects the DUPLEX OUT connector.
Screens on which this field is present
CDMA GENERATOR
Phase/div
This field sets the display resolution for the code domain phase
measurement: 1, 2, 5, 10, 20, or 50 milliradians (mrad). This field is
displayed on the CODE DOM screen’s Marker menu when the
Measurement field is set to Phase.
Screens on which this field is present
CODE DOM (Code Domain Analyzer, IS-95 only): marker controls
menu