Insignia X7510 Cell Phone User Manual


 
148 Getting Connected
Note For secured (Security-enabled) wireless networks, you may be prompted to
provide a username and password.
Next time you use your device to detect wireless networks, you will not see
the pop-up message windows again, and you will not be prompted to enter
the network key of the previously accessed open or secured wireless network
(unless you perform a hard reset which will erase custom settings on your
device).
Note Wi-Fi networks are self-discoverable, which means no additional steps are
required for your device to connect to a Wi-Fi network.
To check wireless network status
You can check the current wireless connection status from:
Title bar
When you enable Wi-Fi, the Wi-Fi ON icon ( ) appears on the title bar.
After Wi-Fi is turned on, your device scans for available wireless networks
and the wireless signal icon ( ) appears on the title bar. The arrows
in this icon move back and forth while your device is scanning for a
wireless network signal. Once your device successfully connects to a
wireless network, the arrows stop moving.
Wi-Fi Status screen
Tap Start > Settings >
Connections tab > WLAN > Main
tab to see the name of the wireless
network that your device is currently
connected to.
The configuration and signal quality
of the wireless network are also
shown.
Configure Wireless Networks screen
Tap Start > Settings > Connections tab > Wi-Fi > Wireless tab.
This screen displays currently available wireless networks. You can also
do the following on the Condigure Wireless Network screen: