Filter
Top Products
NDA-24300 CHAPTER 6
Page 429
Issue 1
SYSTEM OPERATIONS
(2) Data Output - Details on DTFD/DTFDN Command
To obtain the collected Traffic data, you can use the “DTFxxx” or “DTFxxxN” command as shown below.
The commands can be activated by your direct log-in operation onto the MAT, but in normal cases, the com-
mands are to be activated automatically at predetermined intervals assigned by the ATRF/ATRFN command.
Also, each command below corresponds to the Traffic Measurement “TYPE” assigned by the ATRF/ATR-
FN command.
When performing traffic measurement on a node basis:
When performing traffic measurement on a network basis (via TCP/IP):
Note:
For information on the command display images, see Figure 6-22, Figure 6-23, and Figure 6-24.
Measurement “TYPE”
(by ATRF Command)
Command
Name
Full Command Name
1 Terminal Traffic DTF101 Display of Terminal Traffic Data
2 Route Traffic DTF102 Display of Route Traffic Data
3 Station Peg Count DTF103 Display of Station Peg Count Data
4 ATTCON Peg Count DTF104 Display of Attendant Peg Count Data
5 Route Peg Count DTF105 Display of Route Peg Count Data
6 Service Peg Count DTF201 Display of Service Peg Count Data
8 UCD Route Peg Count DTF301 Display of UCD Route Peg Count Data
9 UCD Group Peg Count DTF302 Display of UCD Group Peg Count Data
10 UCD Station Peg Count DTF303 Display of UCD Station Peg Count Data
15 ATT Answer Peg Count DTF501 Display of Attendant Answering Peg Count Data
18 Connection Route Peg Count DTF601 Display of Connection Route Peg Count Data
19 Connection Route Traffic DTF602 Display of Connection Route Traffic Data
Measurement “TYPE”
(by ATRFN Command)
Command
Name
Full Command Name
1 Terminal Traffic DTF101N Display of Terminal Traffic Data for Fusion Network
2 Route Traffic DTF102N Display of Route Traffic Data for Fusion Network
3 Station Peg Count DTF103N Display of Station Peg Count Data for Fusion Network
4 ATTCON Peg Count DTF104N Display of Attendant Peg Count Data for Fusion Network
5 Route Peg Count DTF105N Display of Route Peg Count Data for Fusion Network
6 Service Peg Count DTF201N Display of Service Peg Count Data for Fusion Network
8 UCD Route Peg Count DTF301N Display of UCD Route Peg Count Data for Fusion Network
9 UCD Group Peg Count DTF302N Display of UCD Group Peg Count Data for Fusion Network
10 UCD Station Peg Count DTF303N Display of UCD Station Peg Count Data for Fusion Network
15 ATT Answer Peg Count DTF501N Display of Attendant Answering Peg Count Data for Fusion Network
18 Connection Route Peg Count DTF601N Display of Connection Route Peg Count Data for Fusion Network
19 Connection Route Traffic DTF602N Display of Connection Route Traffic Data for Fusion Network