Filter
Top Products
CHAPTER 8 NDA-24300
Page 546
Issue 1
CSCL: Continuous Change of Station Class
CSCL:
Continuous Change of Station Class
1. Functional Outline
This command can change the station class information (TEC, RSC, SFC) en bloc by designating the range of
the station number.
2. Parameters
Input Data
TN: Tenant Number
STN(START): First Station Number [0-9, #, * (Max. 6 digits)]
Note 1
STN(END): Last Station Number [0-9, #, * (Max. 6 digits)]
Note 1
TEC(OLD): Telephone Equipment Class before change [1-31]
Note 2
,
Note 3
TEC(NEW): Telephone Equipment Class after change [1-31]
Note 2
RSC(OLD): Route Restriction Class before change [0-15]
Note 3
RSC(NEW): Route Restriction Class after change [0-15]
SFC(OLD): Service Feature Class before change [0-15]
Note 3
SFC(NEW): Service Feature Class after change [0-15]
Note 1:
In the bottom part of the display, a check box is provided to determine whether to use "*" and "#" as
a part of the Station Number. If necessary, check the box.
Note 2:
Details on TEC (Telephone Equipment Class) are shown below:
1=DP (10pps) 2=PB
3=DP/PB 4=DP (20pps)
5-11=Not used 12=D
term
13=Data Terminal via D
term
14=Hot Line
15=CAS Line 16=Data Terminal via Data Module
17=Not used 18=Virtual Line Appearance (for D
term
Multi-Line)
19-22=Not used 23=ISDN Terminal
24-26=Not used 27=8 Conference Equipment
28-31=Not used
Note 3:
If you want to change all classes of all specified stations, enter “**” for this parameter.
Buttons
Execute: Click to make the input data valid.
Cancel: Click to cancel the input data.
Exit: Click to exit this command.
Display Data
STN: Station Number
STATUS: Data Entry Result
OK=Data Assignment is successful
Note
Note:
If not OK (i.e. the data entry is not successful), related error message is displayed here.