Filter
Top Products
NDA-24300 CHAPTER 8
Page 525
Issue 1
ATRFN: Assignment of Traffic Measurement Order for Fusion Network
ATRFN:
Assignment of Traffic Measurement Order for Fusion Network
1. Functional Outline
This command is used to assign and delete traffic measurement programs available on the Ethernet. A request
for traffic measurement is performed on a network basis when a traffic measurement instruction has been
assigned by this command. The collected traffic measurement data can be stored on the HD of the MAT
(connected to the NCN: Network Control Node), which can be designated on the basis of traffic measurement
type. Note that this command can be used at the NCN only.
2. Parameters
Input Data
TYPE: Type of Traffic Measurement (1-19) (See Table 8-3)
PORT: Traffic Information Output Terminal Number (0-7: IOC, 8: LAN, 9:NMS)
INTERVAL: Output interval (0, 30-120)
Assign the data (30-120) in 10 minute increments. When assigning 0 (available
when any of TYPE 3-18 is selected), instead specify your desired output time in
the “OUTPUT HOUR/MINUTE” parameters below.
START HOUR
Note 2
,
Note 3
START MINUTE
Note 2
,
Note 3
END HOUR
Note 2
,
Note 3
END MINUTE
Note 2
,
Note 3
OUTPUT HOUR: This data is valid only when INTERVAL=0.
OUTPUT MINUTE: This data is valid only when INTERVAL=0.
START RT: Start External Route Number (available when TYPE 2/5/8 is selected)
END RT: End External Route Number (available when TYPE 2/5/8 is selected)
START C_RT: Start Connection Route Number (available when TYPE 18/19 is selected)
END C_RT: End Connection Route Number (available when TYPE 18/19 is selected)
Note 1:
The selected traffic measurement data, except for TYPE 1 (Terminal Traffic), is collected with the
whole network systems as a single unit.
Note 2:
When time difference exists between the nodes, confirm that the related time difference data, based on the
UCT (Universal Coordinated Time) standard, has been assigned at each node via the ATDF command.
Note 3:
Assign the traffic measurement time period between START HOUR/MINUTE and END HOUR/
MINUTE longer than an hour. Also, if the measurement should be executed throughout a day, assign
the same data in both START HOUR/MINUTE and END HOUR/MINUTE parameters.
Note 4:
If the data for this command is once assigned, the node-level data by the ATRF command is not
cleared, but loses its validity (the network-level data takes precedence).
Table 8-3 Type of Traffic Measurement Explanation
DATA MEANING DATA MEANING
1 Terminal Traffic 2 Route Traffic
3 Station Peg Count 4 ATT Peg Count
5 Route Peg Count 6 Service Peg Count
8 UCD Route Peg Count 9 UCD Group Peg Count
10 UCD Station Peg Count 15 ATT Answering Peg Count
18 Connection Route Peg Count 19 Connection Route Traffic