Filter
Top Products
CHAPTER 8 NDA-24300
Page 562
Issue 1
DPSW: Display Package Switch Status
DPSW:
Display Package Switch Status
1. Functional Outline
This command is used to display the following information on a Line/Trunk or Control circuit card:
[When MAT is in On-Line Mode (=connected to the system)]
• Current status of each switch
• Explanation of each switch function
[When MAT is in Off-Line Mode (= not connected to the system)]
• Explanation of each switch function
Note 1:
When using this command, make sure that each circuit card related database files have already been
installed to your MAT. (See FLINST command for more information.)
2. Parameters
Input Data
KIND: Display Kind (selection)
• (MAT=) On-Line Mode
• (MAT=) Off-Line Mode
TYPE: Circuit Card Type (selection)
• Line Trunk Package
• Control Package
PMN: Port Micro Processor Number
PKG NAME: Circuit Card Name
LP: Local Partition Number [00-06
(Even Number only)]
Note 2
SYSTEM: System
Note 2
0=No.0 System
l=No.1 System
MG: Module Group Number [00-07]
Note 2
UNIT: Unit Number [0-3]
Note 2
ACT/STBY: ACT/ST-BY information
Note 2
0=ACT
l=ST-BY
2=Not used
No: IOC Card Number [0/1]
Note 2
Note 2:
This parameter may appear when “Control Package” is selected in the “TYPE” parameter.
Buttons
Get: Click to view the display data
Page Up: Click to view the next page data (when next page exists).
Page Down: Click to return to the previous page data.
Exit: Click to exit this command.
Display Data
PKG Name: Circuit Card Name
Firm Name/Issue: Firm Name/Issue of the circuit card
Each switch data is also displayed on the dedicated display page.