NDA-24300 CHAPTER 8
Page 561
Issue 1
DPKG: Display of Setting Port Package
DPKG:
Display of Setting Port Package
1. Functional Outline
This command is used to display the circuit card name accommodated in each Group of a specific UNIT.
Note:
When using this command, make sure that each circuit card related database files have already been
installed to your MAT. (See FLINST command for more information.)
2. Parameters
Input Data
MG: Module Group (MG) number [00-07]
UNIT: Unit (U) number [0-3]
Buttons
Get: Click to get information on mounted circuit cards.
Close: Click to exit this command.
Note:
When the Input Data above is entered and the “Get” button is pressed, the related circuit card name is
displayed on a Group basis. However, if the name is not found for some reasons, the following mark
may appear in the relevant display field.
• # → Unidentifiable firmware type.
• ## → Data not found in the FMID (database).
• ### → Group data not assigned.
• * → Circuit card name not found (for the card is in make-busy state, etc.).