Filter
Top Products
CHAPTER 8 NDA-24300
Page 548
Issue 1
DCBD: Display of Call Block Entry Data
DCBD:
Display of Call Block Entry Data
1. Functional Outline
This command is used to display the following Call Block data, assigned to a station:
• Number of station/trunk whose call is to be blocked (in the remainder of this page, denoted as “Restriction
Number”)
• Registered “Restriction Numbers” in total
These data can be obtained by entering any of the station’s Telephone Number (TYPE 1), Physical Station
Number (TYPE 2) or LENS (TYPE 3) in the parameters below:
2. Parameters
Input Data
TYPE: Selection of Input Data Type
TYPE 1 (Input Data = UGN, TELN)
Note
TYPE 2 (Input Data = FPC, TN, STN)
Note
TYPE 3 (Input Data = FPC, LENS)
Note
READ (button to view the Display Data)
EXIT (button to exit)
Note:
When using this command, first choose the input data type (Type 1 - 3) in the “TYPE” selection list box.
Then the following parameters appear, according to the selected data type.
• When TYPE 1 is selected : UGN (User Group Number)
TELN (Telephone Number [Max.16 digits])
• When TYPE 2 is selected : FPC (Fusion Point Code [1-253])
TN (Tenant Number [Max.3 digits])
STN (Physical Station Number [Max.6 digits])
• When TYPE 3 is selected : FPC (Fusion Point Code [1-253])
LENS (Line Equipment Number)