Filter
Top Products
NDA-24300 CHAPTER 8
Page 605
Issue 1
MBTC_LR: Make Busy of Trunk-Continuous-Logical Route Number
MBTC_LR:
Make Busy of Trunk-Continuous-Logical Route Number
1. Functional Outline
This command is used to assign the IDLE/BUSY status of trunks. By using this command, plural trunks can
be placed into IDLE/BUSY state simultaneously per a logical route designated in “LGRT” parameter. Route
number of the MBTC command can be assigned by using logical route.
Note 1:
When logging in to the NCN (Network Control Node), the data of other LN (Local Node) can be
changed. If logging in to a LN, only the DM of self-Node can be changed by this command.
2. Parameters
Input Data
LGRT: Logical route number allocated to the Route Number.
Note 1
TK: Trunk Number
Note 2
START
END
MB: Make Busy Information [0-2]
0=Make Idle
1=Make Busy (Outgoing)
2=Make Busy (Bothway)
Note 3
Note 1:
Prior to this command, logical route number must be allocated by using the ALRTN command.
Note 2:
The status of plural trunks can be changed simultaneously, according to the range of trunk number
assigned and per a logical route.
Note 3:
2=Make Busy (Bothway) is not used.
Display Data
FPC: Fusion Point Code [1-253]
RT: Route Number