Filter
Top Products
CHAPTER 8 NDA-24300
Page 590
Issue 1
FLINST: File Install
FLINST:
File Install
1. Functional Outline
This command is used to install the DPSW-dedicated database files to your MAT. This command is necessary
to provide each circuit card’s various information (such as circuit card name, equipped switch names, etc.)
when your system uses the DPSW/DPKG command.
2. Parameters
Input Data
None
Buttons
Copy: Click to start the data file install.
Exit: Click to exit this command.
<Data Install Procedure>
(1) Start up the FLINST command from the Start menu.
(2) Initial Display of the FLINST command appears. Make sure the proper FD drive name is selected in the
FDD parameter.
(3) Click the Copy button. Then, a message, requiring to insert the first FD into the FDD drive, appears.
(4) Insert the first FD into the FDD of the MAT. Then, click OK.
(5) File copy starts automatically, and the Copy End message appears upon completion.
(6) Click OK. Another message asks you whether the next FD is to be installed or not.
(7) Click OK.
(8) A message, requiring you to insert the second FD into the FDD drive is displayed. Insert the second FD
into the FDD, and click OK.
(9) File copy starts automatically, and the Copy End message appears upon completion.
(10) Click OK. A message asks you whether the next (fourth) FD is to be installed or not.
(11) Click Cancel.