CHAPTER 6 NDA-24300
Page 480
Issue 1
SYSTEM OPERATIONS
Table 6-13 System Initialization With Office Data Loading From HD [Procedure #2]
ACTION
7SEG LED/OPE LAMP/KEY
SETTINGS
START
CPU OPE lamp on the DSP of
active CPU lights steadily green.
IMG0-3 lamps flash.
IMG0 lamp on the DSP of mate
CPU flashes green.
CPU OPE and IMGX lamps on
both DSP go OFF.
STATUS LED (right) on
the DSP of CPU is ON.
STATUS LED (right) on
the DSP of CPU is ON.
STATUS LED (right) on
the DSP of active CPU
is ON.
CPU OPE lamp on the DSP of
active CPU lights steadily green.
IMG0-3 lamps flash.
IMG0 lamp on the DSP of mate
CPU flashes green.
STATUS LED (right) on
the DSP of active CPU
is ON. (ON LINE)
Set the keys on the TOPU as follows.
• PROGRAM KEY → NON LOAD
• SYSTEM DATA KEY → LOAD
END
• HD Initialization
• Office Data Load
• System Initialization
• System starts up again.
Press INITIAL START button on the TOPU.
Turn ON the EFFECT key on the TOPU. (See Figure 6-58)
Confirm system is operating normally.
LOAD
NON LOAD
PROGRM
NON LOAD
SYSTEM DATA
LOAD
PZ-DK222