Palm 700P Cell Phone User Manual


 
Using Your Treo 700P Smartphone 287
Regulatory information
FCC Notice
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
Antenna Care/Unauthorized Modifications
Use only the supplied integral antenna. Unauthorized antenna
modifications or attachments could damage the unit and may
violate FCC regulations. Any changes or modifications not
expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
FCC RF Safety Statement
In order to comply with FCC RF exposure safety guidelines,
users MUST use one of the following types of bodyworn
accessories.
1. A Palm
brand body-worn accessory that has been tested for
SAR compliance and is intended for use with this product.
2. An accessory that contains NO metal (snaps, clips, etc.) and
provides AT LEAST 1.5 cm of separation between the users
body and the unit.
Do NOT use the device in a manner such that it is in direct
contact with the body (i.e., on the lap or in a breast pocket).
Such use will likely exceed FCC RF safety exposure limits See
www.fcc.gov/oet/rfsafety/
for more information on RF exposure
safety.
Specific Absorption Rates (SAR) for Wireless
Smartphones
The SAR is a value that corresponds to the relative amount of
RF energy absorbed in the head of a user of a wireless handset.
The SAR value of a smartphone is the result of an extensive
testing, measuring and calculation process. It does not represent
how much RF the smartphone emits. All smartphone models are
tested at their highest value in strict laboratory settings. But when
in operation, the SAR of a smartphone can be substantially less
than the level reported to the FCC. This is because of a variety of
factors including its proximity to a base station antenna,
smartphone design and other factors. What is important to
remember is that each smartphone meets strict federal
guidelines. Variations in SARs do not represent a variation in
safety.
All smartphones must meet the federal standard, which
incorporates a substantial margin of safety. As stated above,
variations in SAR values between different model smartphones
do not mean variations in safety. SAR values at or below the
federal standard of 1.6 W/kg are considered safe for use by the
public.