5 - 21
No. 99MBC095A
5. MEASUREMENT MODE
• Measurement:
PROG
BUSY
RUN
+NG
GO
-NG
Step 1: In the stand-by state the indicated value includes
errors (i.e. it is smaller than the actual dimension),
since the measured value of Segment 2 is displayed.
Set the start point of “Measuring range of cutting
edge 1” to the measuring point.
PROG
BUSY
RUN
+NG
GO
-NG
Step 2: Enter
DATA C/RUN
.
When “ ” is displayed in the lower
display section, the zero-run measurement
commences.
The numerical data shown in the lower section of
display unit at this time means “Number of cutting
edges not measured yet (number of remaining measurements)”. In this example, the
cutting tool will automatically stop after once it has rotated at the speed of 4 rpm
(number of revolutions) to the finish point of “Measuring range of cutting edge 1”.
PROG
BUSY
RUN
+NG
GO
-NG
Step 3: If
DATA C/RUN
is entered again after the
rotation has stopped rotated, “Temporary
measurement” of Cutting edge 1 will be latched on
the display and then the measurement is completed
for the time being.
PROG
BUSY
RUN
+NG
GO
-NG
Step 4: In the same way, perform measurement for
“Measuring range of cutting edge 2” according to
the procedure of Step 2 and Step 3.
PROG
BUSY
RUN
+NG
GO
-NG
Step 5: In the same way, perform measurement for
“Measuring range of cutting edge 3” according to
the procedure of Step 2 and Step 3.
PROG
BUSY
RUN
+NG
GO
-NG
Step 6: In this example, as the number of cutting edges is
set to “3”, the measured data will be calculated and
the result will be latched on the display at the stage
when the measurement of “Measuring range of
cutting edge 3” is completed, then the measurement
will be terminated.
TIP For the relationship between “Number of workpiece revolutions” and “Number of
averaging times” refer to Section 5.3.6.1 “Odd-numbered-edge cutting tool outside
diameter measurement”.
