4 - 34
No. 99MBC095A
4.5.3.1 F0: Setting the segment
Use this function to set the measurement position (segment). The segment specification and
edge specification methods are provided for this purpose. Both can be selected in the basic
setup.
If this setup mode is entered, the previously established data will flash.
7654321
PROG
Segment
1) Segment specification
Places for displaying the segment numbers are fixed as
shown in the figure at the right. In this example, set to
SEG2.
PROG
Step 1: If the segment setup mode is entered, the previ-
ously established data will be displayed.
PROG
2
Press the
2
key.
PROG
ENT
Step 2: Press the
ENT
key to save the setup data
in memory.
Operation automatically proceeds to the
measurement interval setting.
TIP Segment setup example
PROG
2
4
1. Set to segments (2 + 4).
PROG
1
5
2. Set to segments (1 + 5).
