4 - 24
No. 99MBC095A
m. Setting the application range of calibration (Guidance: )
Select the range of applying the calibration from “All programs” and “For each channel”.
: Applies uniformly to the entire programs.
: Applies individually to each channel (for every 10 program).
(Initial setting:
)
PROG
Step 1: Each time the key is pressed, the selection
item will change sequentially as follows:
→
Step 2: If the
ENT
key is pressed while the target
selection item is blinking, the current setup is
accepted and the operation will automatically
proceed to the next setting.
NOTE When is selected, any programs corresponding to the channel number other
than the one on which the calibration has been performed will take the settings at
shipment, i.e. without being calibrated.
n. Setting the application range of presetting and mastering (Guidance: )
Select the range of applying the presetting and mastering from “For each program”, “All
programs”, and “For each channel”.
: Applies individually to each program.
: Applies uniformly to the entire programs.
: Applies individually to each channel (for every 10 program).
(Initial setting: )
PROG
Step 1: Each time the key is pressed, the selection
item will change sequentially as follows:
→ →
Step 2: If the
ENT
key is pressed while the target
selection item is blinking, the current setup is
accepted and the operation will automatically
proceed to the next setting.
o. Setting the number of programs to be used (Guidance: )
Select the number of programs to be used from “100” and “10”.
: 100 program mode
: 10 program mode
(Initial setting: )
PROG
Step 1: Each time the key is pressed, the selection
item will change sequentially as follows:
→
Step 2: If the
ENT
key is pressed while the target
selection item is blinking, the current setup is
accepted and the operation will automatically
proceed to the next setting.
