2 - 3
No. 99MBC095A
2. SETUP
IMPORTANT • If the dummy ID unit is still mounted, “ ”
is displayed in the lower section of the display. If
this is the case, turn off the power and replace the
dummy ID unit with a proper ID unit.
PROG
• If the ID unit has not been installed, an error
display as shown at the right will appear in the
upper section of the data display unit and the
operation of this unit stops.
PROG
• If the ID unit is not installed or if the serial number of
the Measuring Unit is not consistent with that on the
ID unit, the system will not work and an error code
as shown at the right will be displayed at power on.
At the same time, the 6-digit serial number of the
measuring unit is displayed for confirmation.
If the
C
key has been pressed to enter the ready state, measurement can be
automatically started. However, the measuring accuracy can not be guaranteed. If
the optional dual-type add-on unit is used to perform measurement with two
Measuring Units, make sure that the serial numbers of the two Measuring Units,
which are connected to the “TRANSMITTER-1” connector and “TRANSMITTER-2”
connector, are identical. If neither of the two Measuring Units has a serial number
identical to that of the ID unit, a serial number of the Measuring Unit on the
“TRANSMITTER-1” side will be displayed in the upper display section, and that of
the Measuring Unit on the “TRANSMITTER-2” side will be displayed in the lower
display section.
ID
Remote interlock
GND lead wire
Signal cable
ID unit
Connecting cable
Power
cord
Step 3: Connecting the connecting cable (except for the LSM-500S)
Connect the cable which runs from the base of the Measuring Unit to the lower
connector (5-pin) on the rear panel of the emission unit.
Step 4: Connecting the signal cable
Insert the round plug (12-pin) of the signal cable into the upper connector (12-pin)
on the rear panel of the emission unit. Tighten the ring screw to firmly secure the
connectors.
Insert the square connector (15-pin) on the other end of the signal cable into the
connector “TRANSMITTER-1” at the upper left of the display rear panel and tighten
the securing screws.
If measurement is performed with two Measuring Units while using the optional
dual-type add-on unit, plug the cable from the second Measuring Unit into the
“TRANSMITTER-2” connector, then firmly tighten the screws.
Step 5: Connecting the power cord and GND lead wire
Connect the supplied power cord to the AC connector at the upper right on the rear
panel of the Display unit. Also be sure to ground the Display unit with the GND lead
wire for improved resistance to noise.
PROG
