4 - 2
No. 99MBC095A
4.1.1 Outline of the basic setup procedure
B1 a. Setting whether to perform GO/NG judgment result output and analog output in the ready state
b. Setting the analog output voltage if Err-0 occurs
c. Setting the display message if Err-0 occurs
d. Setting the display message at the start of measurement
e. Setting the averaging method
f. Setting the GO/NG judgment method
g. Setting whether the target value is copied to the reference value
B2 a. Setting the workpiece type (opaque or transparent)
b. Setting whether to perform ultra-fine wire measurement
c. Setting the simultaneous measurement
d. Setting the dual-unit measurement
e. Setting the DXY-type calculation
f. Setting the method of specifying segments
B3 a. Setting the abnormal value elimination function
b. Setting the automatic workpiece detection function
c. Setting the number of scans
d. Setting the group judgment
e. Setting the output function to the RS-232C/GP-IB interface
f. Setting the odd-numbered-edge cutting tool measurement
B4 a. Setting the use of the RS-232C port
b. Setting the RS-232C communication baud rate
c. Setting the RS-232C communication data bits
d. Setting the RS-232C communication parity bit
e. Setting the delimiter for communication
f. Setting the RS-232C line control
B5 a. Setting the RUN input function from the I/O interface
b. Setting the OFFS input function from the I/O interface
c. Setting the GO output function from the I/O interface
B6 a. Setting the use of DCU
Use the and keys to switch between modes.
Mode No. Setup contents
Ready state
B0 a. Setting the resolution
b. Setting the number of blanked out (display-off) digits
c. Setting whether a comma (",") is inserted after the thousandth digit
d. Setting the buzzer function
e. Setting the period of the display latch timer
Basic setup mode (can be entered by pressing the key + Power ON)
SET
