4 - 7
No. 99MBC095A
4. SETTING UP THE MEASURING CONDITIONS
d. Setting the buzzer function (Guidance: )
Set whether or not to enable (key input sensing sound and key entry error sound) and
(±NG judgment sound). Note that the system error sounds (indicating that the printer or
Digimatic Output Unit is not connected, or other system failures) are not disabled with this
setting.
The types of buzzer sound are as follows:
1. Key input sensing sound: very short beep (0.05 sec)
2. Key entry error sound: short beep (0.2 sec)
3. ±NG judgment sound: long beep (1 sec)
4. System error sound: repeated short beeps at intervals of 0.2 seconds
: Sounds a buzzer in all cases.
: Enables the key input sensing sound + key entry error sound
: Sounds a buzzer when the judgment result is ±NG
: Sounds a buzzer only if a system error occurs
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → → . If the
desired option is flashing, press the
ENT
key.
When the setup for the buzzer function is com-
pleted, operation automatically proceeds to the
setting of the display latch timer.
e. Setting the display latch timer (Guidance: )
Set the period the measurement result display is to be latched (held) on the display if a
single-run measurement or continuous-run measurement is performed. Specify a value
between 0 and 99 seconds. “0” seconds specifies an infinite (latch state not canceled).
(Default setting: 10 seconds)
PROG
PROG
1
PROG
5
PROG
ENT
Step 1: This is an example of the display latch timer being
set to 15 seconds.
Enter
1
and
5
in this order.
Step 2: Press the
ENT
key to save the setup data in
memory.
The operation automatically proceeds to B1:
Setting the output function in the ready state.
