6 - 19
No. 99MBC095A
6. INTERFACE UNIT
(10) UNLOCK
(a) Format: UNLOCK
(b) Description: Releases the key lock state and enables key operations again.
(c) Example: Reception command UNLOCK
Response command OK
(11) SHL
(a) Format: SHL pp (pp: threshold level, 5 to 95%)
(b) Description: If “Performing the ultra-fine wire measurement” is specified in the basic setup,
designating this command results in ER6.
Used to measure such as the width of a tape, which has a good transparency.
(c) Example: Reception command SHL 50
Response command OK
(d) Supplement: Refer to Section 3.2.4.1, “Transparent object (Workpiece that transmits light)”.
(12) RP (RP FORMAT)
(a) Format: RP
(b) Description: This is used to confirm the setup contents, if the measuring conditions and
operating conditions set are received as the response.
(c) Example: Reception command RP command
Response command PROGRAM, SG
∆ 2, M3, LL∆ D 5.988, LH∆ 6.010,
REF6.000, SCL1, OF∆ 0, PR∆ 3, PRT0, SMP20, MAX,
ST∆
(13) SET
(a) Format: SET
Segment specification *1 , SG sssssss
Edge specification *1 , SG aaa-bbb
Number of scans for arithmetical average , MN nnnn
Measurement interval number at moving average , MS m
Number of scans for moving average , MNH nnnn
Lower abnormal limit *2 , EL±ddd.dddd
Upper abnormal limit *2 , EH±ddd.dddd
Abnormal count value *2 , CNT aaa
Lower limit *1 , LL±ddd.dddd
Upper limit *1 , LH±ddd.dddd
, L1±ddd.dddd
Multi-limit selection value *1 , L2 • • • •
, L6±ddd.dddd
Target value *1 , N±ddd.dddd
Lower tolerance limit *1 , LO±ddd.dddd
Upper tolerance limit *1 , UP±ddd.dddd
Reference value *3 , REF±ddd.dddd
Scale value , SCLc
Positive preset *4 , PS±ddd.dddd
Negative preset *4 , PSM±ddd.dddd
Data output condition *5 , PRr
Periodic data output timer , PRT ttt
