4 - 33
No. 99MBC095A
4. SETTING UP THE MEASURING CONDITIONS
2. Setting each setup item
• Use the numeric keys for setting the setup value, such as an preset value, and use the
and keys for selecting the item, such as the statistical item of the sample
measurement.
• Press the
ENT
key to accept and save the setup data. After the setup content has been
accepted, the operation automatically proceeds to the next setup item.
3. Setup values that must meet the large/small relationships
The setup values for GO/NG judgment should meet the following relationships: Abnormal
lower limit < Abnormal upper limit, Lower tolerance limit < Upper tolerance limit, and
Lower limit value < Upper limit value.
If the previously specified setup value needs to be modified to a great extent, it is recom-
mended to first enter the new setup value thats meets the existing large/small relationship
or, for safety, cancel the both sides to 0 then set them again.
4. Confirming the setup contents of each setup item
To confirm the setup contents of each setup item use only the
ENT
key, which does not
affect the setup contents.
5. Terminating the function setup mode
• If the
SET
key is pressed while the function setup number is flashing, operation
returns to the ready state.
• If the
SET
key is pressed in the setup mode of each setup item, operation returns to
the selection of a function setup number. If the
SET
key is pressed again at this point,
operation returns to the ready state.
• If the power is turned off halfway to the setup operation, on-going setup contents will
not be saved in memory. The contents must be set again.
4.5.3 Function setup mode
PROG
• If the function setup mode is entered using the
SET
key in the ready state, the function setup number
will be flashing as shown in the figure at the right.
• Each time the key is pressed when the function
setup number is flashing, it will change as follows:
→ → → → → → → → →
. Press the
ENT
( ) key while the desired
function setup number is flashing to enter the setup
mode. If the key is pressed, this order will be
reversed.
• If a key other than the , , ,
ENT
and
SET
keys are pressed during the
selection of a function setup number, an operation error will result.
• If each piece of setup data is accepted with the
ENT
key in the corresponding setup
mode, the operation will automatically proceed to the next setup item.
