4 - 5
No. 99MBC095A
4. SETTING UP THE MEASURING CONDITIONS
4.1.2.1 Selecting and setting the function in the B0 mode
a. Setting the resolution (Guidance: )
Set the resolution of the Measuring Unit. The resolutions that can be set for the Measuring
Units are given in “Table 4.5.2.1A” and “Table 4.5.2.1B”.
PROG
Step 1: Each time the key is pressed the displayed
setup option (number) changes in the following
order: → → ... → → → . If the
desired option is flashing, press the
ENT
key. If
the resolution setting has been made, the operation
automatically proceeds to the setting for the
number of blanked out digits.
The initial setup option is set to .
1. Resolution using the metric system (Unit: µm) Table 4.5.2.1A
emanledoM
01234567
S005-MSL 10.020.050.01.02.05.01 01
S105-MSL
10.020.050.01.02.05.01 01
S305-MSL 20.050.01.02.05.01 01001
S605-MSL
50.01.02.05.012 01001
S215-MSL
1.02.05.0125 01001
S615-MSL
1.02.05.0125 01001
2. Resolution using the inch system (Unit: inch) Table 4.5.2.1B
emanledoM
01234567
S005-MSL
100000.100000.200000.500000.10000.20000.50000.5000.
S105-MSL
100000.100000.200000.500000.10000.20000.50000.5000.
S305-MSL
100000.200000.500000.10000.20000.50000.5000.500.
S605-MSL
200000.500000.10000.20000.50000.1000.5000.500.
S215-MSL
10000.20000.50000.1000.2000.5000.500.
.tinUgnirusaeMhcaefognittestluafedehtwohsserugifdedahsehT:1etoN
fosnmulocehtnisnoituloseR:2etoN " 0" .snacs23morfdeniatboebnachcihwesohtwohs
htiwsnmulocehtnisnoituloseR " 1" .snacs61morfdeniatboebnachcihwesohtwohs
tnemerusaemafotigidtnacifingistsaeleht,8ot1neewtebteserasnacsforebmunehtfI:3etoN
.2ro,1,0.oNottessinoitulosererehwtuodeknalbyllacitamotuaeblliw
.ycaruccagnirusaemehtecudernetfoyamnoituloseregralootagnittestahtetoN:4etoN
forebmunehttes,eesottluciffiddnatcatniylesolcerastigiddeyalpsidehterehW
LSM-516S 500000.10000.20000.50000.1000.2000.5000.500.
500000.
blank-out digits or mark the thousandth digit function in the basic setup mode: b0.
IMPORTANT Changing the resolution will cancel all the clibration values (HIGH CAL and LOW
CAL), offset value, mastering, abnormal value eliminating limits, GO/NG judgment
criteria, reference value, and setup values for the automatic workpiece detection.
Therefore, changing of the resolution should be carried out first.
