2
2 - 1
No. 99MBC095A
This chapter describes the connection between the Display Unit and
Measuring Unit.
SETUP
2.1 Unpacking and Acceptance Check
Your LSM has been thoroughly inspected prior to shipment. The mechanical, electrical, and
optical systems are guaranteed to operate properly.
Unpack the package and check that the accessories, for the Display Unit or Measuring Unit,
and signal cables, etc., are intact and not damaged.
Contact Mitutoyo if anything is damaged or missing.
2.2 Connecting the Cables
Make sure that the power switch is turned off (turn the key switch counterclockwise to align
with “O”, then pull it out), then connect the cables according to the following procedure.
Step 1: Integrating the option interface
For the option interface (Dual-type Add-on Unit, Second Analog I/O Unit, BCD
Output Unit, GP-IB Unit, and Digimatic Output Unit) to become available with the
LSM, it must be installed by referring to Section 6.3 “Installing the Optional Inter-
face Unit”.
For information about the setup switches on the BCD and GP-IB interface units refer
to Section 6.2.3, “BCD Interface” and Section 6.2.4, “GP-IB Interface”, respectively.
