3 - 33
No. 99MBC095A
3. DISPLAYS AND KEY OPERATIONS
3.3 Outline of the Display Contents
Displays of this system are effected by the display unit and guidance LEDs.
3.3.1 Display unit
The name of each part of the display unit and the LEDs are given below:
PROG
BUSY
RUN
+NG
GO
-NG
LOCK DUALP.SETCAL S.E
LD1 ON
LD2 ON
Data display unit (fluorescent display tube)
Upper display section
Lower display section
Measurement state guidance
BUSY LED
RUN LED
GO/NG judgment LEDs
LD oscillation LED
W.P. (Work Position) LED
3.3.2 Data display unit
1) Numeric and character display
• Single measurement: Turns off.
• Simultaneous measurement:
Displays a background program number.
• Displays a settting item in the single measurement.
• Single measurement: Displays a setup value.
• Simultaneous measurement:
Displays the measured data of a background program.
• Displays the unit of measurement.
• Displays the measured
data of a foreground program.
• Displays a foreground program number.
2) Operation state guidance
• LOCK: Turns on in the key lock state, which is initiated by pressing both the
SHIFT
and
LOCK/
UNIT
keys. If these keys are input the key lock state will be can-
celed.
• CAL: Turns on if the calibration (HIGH) is specified.
• P.SET: Turns on if the preset function is active.
• S.E: Turns on if statistical processing is activated.
• DUAL: Turns on if simultaneous measurement is specified.
