4 - 23
No. 99MBC095A
4. SETTING UP THE MEASURING CONDITIONS
PROG
h. Space for additional functions (Guidance: )
(Initial setting :
)
If the
ENT
is entered, the operation automatically
proceeds to the next setting.
PROG
i. Space for additional functions (Guidance: )
(Initial setting :
)
If the
ENT
is entered, the operation automatically
proceeds to the next setting.
PROG
j. Space for additional functions (Guidance: )
(Initial setting : )
If the
ENT
is entered, the operation automatically
proceeds to the next setting.
k. Setting the STB length of I/O analog interface (Guidance: )
Selects the STB length of the I/O Analog Interface (strobe) output.
: Automatically makes up the setting with the specified number of averages.
: STB length = 0.1 ms
: STB length = 0.3 ms
: STB length = 2 ms
: STB length = 5 ms
: STB length = 10 ms
: STB length = 20 ms
: STB length = 50 ms
: STB length = 100 ms
(Initial setting: )
PROG
Step 1: Each time the key is pressed, the selection
item will change sequentially as follows:
→ → ... → →
Step 2: If the
ENT
key is pressed while the target
selection item is blinking, the current setup is
accepted and the operation will automatically
proceed to the next setting.
l. Setting the input software filter (Guidance: )
Select the filter length for input signals.
: Filter length = 5 ms
: Filter length = 20 ms
: Filter length = 2 ms
(Initial setting: )
PROG
Step 1: Each time the key is pressed, the selection
item will change sequentially as follows:
→ →
Step 2: If the
ENT
key is pressed while the target
selection item is blinking, the current setup is
accepted and the operation will automatically
proceed to the next setting.
