6 - 33
No. 99MBC095A
6. INTERFACE UNIT
3) Input signal to select program number
0b/1b/2b/3b/TFIHS/GRP/noitpircseD
ffOffoffoffoffono
0xPrebmunmargorptceleS
nOffoffoffoffono
1xPrebmunmargorptceleS
ffOnoffoffoffono
2xPrebmunmargorptceleS
nOnoffoffoffono
3xPrebmunmargorptceleS
ffOffonoffoffono
4xPrebmunmargorptceleS
nOffonoffoffono
5xPrebmunmargorptceleS
ffOnonoffoffono
6xPrebmunmargorptceleS
nOnonoffoffono
7xPrebmunmargorptceleS
ffOffoffonoffono
8xPrebmunmargorptceleS
nOffoffonoffono
9xPrebmunmargorptceleS
ffOffoffoffonono
x0PrebmunlennahctceleS
nOffoffoffonono
x1PrebmunlennahctceleS
ffOnoffoffonono
x2PrebmunlennahctceleS
nOnoffoffonono
x3PrebmunlennahctceleS
ffOffonoffonono
x4PrebmunlennahctceleS
nOffonoffonono
x5PrebmunlennahctceleS
ffOnonoffonono
x6PrebmunlennahctceleS
nOnonoffonono
x7PrebmunlennahctceleS
ffOffoffononono
x8PrebmunlennahctceleS
nOffoffononono
x9PrebmunlennahctceleS
NOTE All input signal must be off before the new input signal is on.
However, signal “b0” to “b3” and “SHIFT” is able to be on before signal “PRG” is on.
4) Output signal
Signal
A_-NG, A_GO,
A_+NG
A_L1_to_L7
GTJ_-NG, GTJ_GO,
GTJ_+NG
ACK
CNT
Description
• Output of GO/-NG judgment result when “1 JDG.M” is set to “LL-LH” or “N-UL”.
• And multi-limit judgment result when “1 JDG.M” is set to “L1-L6”.
• Data for program Px0 to Px4 will be output in the simultaneous-program measurement.
• Output of GO/-NG judgment result when “1 JDG.M” is set to “LL-LH” or “N-UL”.
• And multi-limit judgment result when “1 JDG.M” is set to “L1-L6”.
• The output signal is equivalent to “A” in the signal-program measurement.
• Data for program Px5 to Px9 will be output in the simultaneous-program measurement.
• Single or simultaneous-program measurement are selected by basic setup (“2 PROG”).
• This is usually set to ON (LOW level) but turns to OFF (HIGH level) when a segment
error occurs.
• Outputs the results of group in group judgment. (Basic setup “3 GTJ”=“USE”)
• This is set to ON (LOW level) during measurement (single-run or continuous-run).
STB
• Before outputting a judgment result, this will be output (Low) as a cofirming signal.
• Turns Low level if abnormal data to be discarded occurred successively.
• It is need the setting of “2 CNT” by Function setup. And “3 ADE” is set to “USE” or
“USE2” by Basic setup.
ER0
B_-NG, B_GO,
B_+NG
B_L1_to_L7
