3 - 35
No. 99MBC095A
3. DISPLAYS AND KEY OPERATIONS
3.4 Outline of Key Operations
On this system operate the keys as follows.
PROG
• The
STAT/S.E
key, for example, has two functions as
indicated on the upper and lower portions of the key
top. The function on the upper portion can be activated
by simply pressing the key, and the one on the lower
portion can be activated by pressing the key while
holding down the
SHIFT
key. If the
SHIFT
key is
pressed, the currently displayed program number flashes
for about 10 seconds until another key is pressed.
During this period one of the functions in the upper
portions of the keys can be selected. Press the
STAT/S.E
key while the program number is flashing.
• To enter the reference gage values, such as HIGH CAL, LOW CAL and preset, or other
setup values such as reference values and GO/NG judgment criteria, etc., the numeric keys
(
0
to
9
,
.
,
+/
-
) and arrow keys ( , , and ) can be
used.
a) If a setup value entry is started with a numeric key and an arrow key is pressed halfway,
an operation error will result. The following example shows a case of an preset value.
PROG
1. Enter the setup mode of the preset function.
The least significant digit of the existing preset value
is flashing.
PROG
2. Change the value to 12.00 mm.
Press the
1
key.
PROG
3. If an arrow key is pressed at this point, an operation
error occurs, however the display does not change.
PROG
4. To enable the entry of an arrow key, press the
C
key to cancel the setup value.
Now the arrow keys are operable.
