A SERVICE OF

logo

6 - 40
No. 99MBC095A
6.2.3 BCD interface
This interface outputs data in parallel format. The output data consists of a positive true
logic/negative true logic signal and a decimal number (BCD)/Hexadecimal number (HEX).
6.2.3.1 Method of use
1) Installation and setup of the interface
By referring to Section 6.2.3.3 Specification, set the jumper switches and DIP switches
to meet the purpose of measurement.
Install this interface unit in the Display Unit. For the installation method, refer to Section
6.3 Installing the Optional Interface Unit.
6.2.3.2 Name of each part
18
36 19
1
BCD I/F
1JP3
1
1
JP2
SW1
JP1
1
Connector
BCD interface connector
Connector 1 pin mark ( )
Jumper switch: JP1
Jumper switch: JP2
DIP switch: SW1
Jumper switch: JP3
fognitsisnoCytitnauQ
ecafretniDCB1
)06303-75(rotcennoC1
elbacgnitcennoC1