4 - 11
No. 99MBC095A
4. SETTING UP THE MEASURING CONDITIONS
4.1.2.3 Selecting and setting the function in the B2 mode
a. Setting the workpiece type (Guidance: )
Set whether the workpiece is an opaque object or transparent object.
: Workpiece is an opaque object.
: Workpiece is a transparent object.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. The operation
automatically proceeds to setting whether to
perform ultra-fine wire measurement.
TIP If is selected for the workpiece type, the guidance for the selection of the
segment specification method is not displayed. It is omitted (the segment specifica-
tion process is entered directly).
b. Setting whether to perform ultra-fine wire measurement (Guidance: )
Set whether to perform the ultra-fine wire measurement.
: Performs ultra-fine wire measurement.
: Does not perform ultra-fine wire measurement.
(Default setting: on the LSM-500S and other models that have been
factory set for extra-fine wire measurement; otherwise no setup guidance will
be displayed).
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
. While the desired setup option is
flashing, press the
ENT
key. If is
selected, the operation automatically proceeds to
B3: Setting abnormal value elimination function.
Otherwise, proceeds to Setting the simultaneous
measurement.
NOTE About ultra-fine wire measurement
1. If the Display Unit is initialized (turn on the power while holding down the
C
key) on the LSM-500S, the option for ultra-fine wire measurement be-
comes the default setting.
2. If is selected on the LSM-500S so that ultra-fine wire measurement is not
performed, the following measuring range will be applied.
egnargnirusaeM
)yrotcaf(dradnatS
egnargnirusaemtes
tnemerusaemeriwenif-artlufi
demrofrepebottonsi
S005-MSLmm2ot500.0mm2ot1.0
