4 - 12
No. 99MBC095A
TIP If is selected to perform ultra-fine wire measurement, setup guidance for the
following will not be displayed: Setting the simultaneous measurement, setting the
dual-measurement, segment setting, setting the automatic workpiece detection
function, and group judgment.
c. Setting the simultaneous measurement (Guidance: )
Set whether to perform simultaneous measurement.
: Does not perform simultaneous measurement. (performs single measure-
ment)
: Performs simultaneous measurement.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and
While the desired setup option is
flashing, press the
ENT
key. Operation automati-
cally proceeds to setting the dual-unit measure-
ment.
TIP If (simultaneous measurement) is selected
If simultaneous measurement is selected, the setup guidance for the following will
not be displayed: Selecting the averaging method, segment specification, and setting
the group judgment.
d. Setting the dual-unit measurement (Guidance: )
Set whether to perform dual-unit measurement.
: Uses DW-type setup.
: Uses DXY-type setup.
: Uses DF-type setup.
: Suspends operation of a Measuring Unit.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order:
→ → → . While the desired
setup option is flashing, press the
ENT
key.
If is selected, the operation enters the
process for setting the calculation method for the
DXY-type; if or is selected, the
operation enters the setup process for segment
specification; if is selected, the operation
enters the process for setting the abnormal value
elimination function.
