4 - 16
No. 99MBC095A
f. Setting the odd-numbered-edge cutting tool measurement function (Guidance : )
Set whether the odd-numbered-edge cutting tool measurement function is used.
: Does not use the odd-numbered-edge cutting tool measurement function.
: Uses the odd-numbered-edge cutting tool measurement function.
This must be selected when the reference edge is located at the Segment 1 side.
: Uses the odd-numbered-edge cutting tool measurement function.
This must be selected when the reference edge is located at the Segment 3 side.
(Initial setting : )
PROG
Step 1 : Each time the key is pressed, the selection
item will change sequentially as follows:
Step 2 : If the
ENT
key is pressed while the target
selection item is blinking, the current setup is
accepted and the operation will automatically
proceed to B4: Setting the RS-232C port.
NOTE If one of the following setup items are selected, “ : Does not use the odd-
numbered-edge cutting tool measurement function” will be automatically accepted as
the intended setting without showing the setup guidance for odd-numbered-edge
cutting tool measurement.
1. Where “ : Moving average” is set for the “B1.e. Setting the averaging
method”.
2. Where “ : Ultra-fine wire measurement” is set for the “B2.b. Setting
whether the Ultra-fine wire measurement is performed”.
3. Where “ : Simultaneous measurement” is set for the “B2.c. Setting the
simultaneous measurement”.
4. Where “ , , or ” is set for the “B2.d. Setting the dual measurement”.
5. Where “ : Edge specification” is set for the “B2.f. Selecting the segment
specification method”.
6. Where “ or ” is set for the “B3.b. Setting the workpiece auto-
matic detection”.
TIP For practical measurement examples refer to Section 5.3.6 “Application of the odd-
numbered-edge cutting tool measurement”.
