4 - 6
No. 99MBC095A
b. Setting the number of blank-out digits (Guidance: )
Here, set the number of blank-out digits for measurements to be displayed in the display
unit. This blank out does not apply to the output to BCD interface, RS-232C/GP-IB
interface, printer, Digimatic output unit, and the display of setup value.
: No blank out (all digits are displayed) →
: The least significant digit is blanked out. →
: The least significant two digits are blanked out. →
(Default setting is .)
PROG
Step 1: Each time the key is pressed the displayed
figure changes in ascending order:
→ →
→ .
While the figure to be set is flashing, press the
ENT
key.
After accepting the specified value, the display proceeds to the setup stage of the
next item.
c. Putting a comma after the thousandths digit (Guidance: )
Set whether a comma ( ,) is inserted after the thousandths digit.
: Not displayed →
: Displayed →
(Default setting is .)
PROG
Step 1: Each time the key is pressed the displayed
string toggles between and .
Select the setting and press the
ENT
key.
After accepting the specified digit position, the
display proceeds to the setting the buzzer function.
