4 - 22
No. 99MBC095A
PROG
Step 1: Enter a value with numeral keys while the setting
is flashing.
Step 2: Press the
ENT
key while an entered value is
flashing. After the entry is made, the next setting
item will be displayed.
f. Setting for detecting dirty protection glass (Guidance: )
Sets the function for detecting dirty protection glass. (Functions at power on.)
If the protection glass is dirty, will be displayed. This error display can be
cleared by pressing the
C
key. The ready state will be entered.
If the protection glass is found to be dirty, refer to Section 8.2, "Measuring Unit".
A warning will be issued if the protection glass has become too dirty and measuring
accuracy will be affected. To ensure precision measurements, clean the protection glass
before any warning is likely to be issued.
: No use of the dirty protection glass detection function.
: Use of the dirty protection glass detection function.
(Default value: )
PROG
Step 1: Setting changes between and at
each entry of .
Step 2: Press the
ENT
key while the setting is flashing.
After the entry is made, the next item to be set
will be displayed.
NOTE A very small workpiece (e.g., smaller than 0.05 mm for the LSM-500S) is likely to be
regarded as a piece of dirt. If a very small workpiece is to be measured, perform a
check with the workpiece removed.
g. Setting the measurement mode (Guidance: )
Used to select measurement mode for measurement of, for example, the transparent sheet
width. For detailed information, refer to Section 3.2.4.1 Transparent object.
Be aware that any change in the parameter setting greatly affects the measured data
(measuring accuracy).
: Use this setting for ordinary measurements.
: Do not use this setting for ordinary measurements.
: Only select for changing the SHL settings.
(Default value: )
PROG
Step 1: Setting changes to , , and in
this sequence for each entry of .
Step 2: Press the
ENT
key while the setting is flashing.
After this entry is made, the next item to be set
will be displayed.
