4 - 4
No. 99MBC095A
4.1.2 Description of each mode
1. Data display unit
If the basic setup mode is entered, the following display appears.
The basic setup number “
” will be flashing in the most significant digit of the upper
display section, and the guidance for the setup item, followed by the setup value, will be
shown at the right of the setup number.
In the lower display section “ ” will be displayed.
PROG
Basic setup number: 1 digit
Setup item guidance: 3 to 8 digits
Setup data: 1 to 7 digits
Unit: 2 digits
The set display of "BASIC PROG"
2. Selecting the basic setup number
• Each time the key is pressed when the basic setup number is flashing the
function setup number digit changes as follows: → → → → → →
→ . To enter the desired setup mode press the
ENT
key when its setup number is
flashing. If the key is pressed, the setup mode will change in reverse order.
• If a key other than , ,
ENT
, or
SET
is pressed during the selection of a
basic setup number an operation error will result.
• When each piece of setup data is accepted with the
ENT
key in the corresponding
setup mode, the operation will automatically proceed to the next setup item.
3. Setting each setup item
• Except for setting up the display latch timer, select the setup item using the or
key and accept the setup specification by pressing the
ENT
key. When the setup
content is accepted, the operation will automatically proceed to the next setup item. In
setting the display latch timer, it is better to use the numeric keys rather than the arrow
keys, which, however, are valid.
4. Confirming the setup contents of each setup item
To confirm the setup specification of each setup item use only the
ENT
key, which does
not affect the setup specifications.
5. Terminating the basic setup mode
• If the
SET
key is pressed while the basic setup number is flashing, the setup contents
modified in this session will be saved, and the system will restore the state that is
entered just after the power is turned on.
• If the
SET
key is pressed in the setup mode of each setup item, the operation returns
to the selection of a basic setup number. If the
SET
key is pressed again at this point ,
the setup contents modified in this session will be saved, and the system will restore the
state that is entered just after the power is turned on.
• If the power is turned off halfway the setup operation, setup specifications made will
not be saved. If this is the case, setup should be repeated from the beginning.
