4 - 8
No. 99MBC095A
4.1.2.2 Selecting and setting the function in the B1 mode
a. Setting the output function in the ready state (Guidance: )
Set whether to perform GO/NG judgment result output and analog output in the ready
state.
: Neither kind of output is performed in the ready state.
: Both kinds of output are performed, even in the ready state.
(Default setting:
)
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and .
While the desired setup option is flashing, press
the
ENT
key. When the setup for this function
has been completed, the operation automatically
proceeds to the setting for the analog output
voltage in the event of Err-0.
b. Setting the analog output voltage if Err-0 occurs (Guidance: )
Set the analog output voltage in the event of Err-0 (specified workpiece not present).
: Output voltage 0V
: Output voltage +5V
: Output voltage -5V
(Default setting: V)
PROG
Step 1: Each time the key is pressed the displayed
setup option changes in the following order: →
→ . While the desired setup option is
flashing, press the
ENT
key. When the setup for
this function has been completed, the operation
automatically proceeds to the selection of the
display message for Err-0.
c. Selecting the display message if Err-0 occurs (Guidance: )
: Displays “ ”.
: Displays “ ” as the least significant digit.
(Default setting: )
PROG
Step 1: Each time the key is pressed the displayed
setup option toggles between and .
While the desired setup option is flashing, press
the
ENT
key. The operation automatically
proceeds to the selection of the display message at
the start of measurement.
