No. 99MBC095A
3. DISPLAYS AND KEY OPERATIONS
90
•
+/-
C
SHIFT
STAT
S.E
SHIFT
SHIFT
READ
SHIFT
S.PR
PRINT
S.PR
PRINT
SHIFT
C.RUN
DATA C
RUN
DATA C
RUN
DATA C
RUN
C
ENT
Key name • In the ready state
• In the display-latched state
• At single-run measurement
• At continuous-run measurement
• At setup
• Combined use with power-on
• operation
• Operation error
• Operation error
• Shift key
• To enter the function indicated in
• the upper portion of a double-
• function key, such as the
key, hold down the
• before pressing the key.
• A foreground program number will
• flash for about 10 seconds.
• Cancels the error that occurred
when the power was turned on.
• Cancels the latched state and
• returns to the ready state.
• Changes the program number
• Operation error
• Operation error
• Operation error
• Operation error
• Entry of +
• (to set the light amount detecting
• function) is valid when the function
• setup item number flashes in the
• function setup mode.
• Performs single-run measurement
• (even in the display-latched state).
• Results in a single-run
• measurement error.
• Quits the measuring operation for
• continuous-run measurement.
• Operation error
• Starts continuous-run measurement
• (even in the display-latched state).
• Quits the measuring operation for
• continuous-run measurement
•
(same as ).
• Operation error
• Operation error
• Prints out the previous
• measurement data.
• Prints out the data currently
• displayed in the display-latched
• state.
• Results in a single-run
measurement error.
• Prints out the previous
• measurement data in
• continuous-run measurement.
• Operation error
• If the printer is active, prints out all
• the statistical processing data and
• clears the statistical memory.
• If the printer is not active, results in
• an operation error.
• Operation error • Operation error
• Aborts the measurement and
• returns to the ready state.
• Operation error
• Enters a decimal point.
• Inverts the sign of the setup value.
• Cancels the setup value or resets
• it to initial value.
• Cancels the error state.
• + power-on will enter the
• initialization mode of the Display
• Unit.
• Enters the setup data.
• Enters in the mode to cancel the
previous measurement result.
• To accept the cancellation and
returnto the standby state, press the
key while “CANCEL” is
blinking in the upper display section.
