Filter
Top Products
104 Chapter 1
GPIB Command Dictionary
CANalyzer subsystem
:EVENt:TRIGger <string>
:EVENt:TRIGger?
These commands set/query the trigger setting of the CDMA
ANALYZER screen.
Syntax
CAN:EVEN:TRIG ‘27 ms’
‘20 ms’
‘80 ms’
‘2 s’
‘Delay’
‘Immed’
CAN:EVEN:TRIG?
Example
CAN:EVEN:TRIG ‘Delay’
!sets the trigger to run after the delay has been set by the
CAN:EVEN:TRIG:DEL command.
CAN:EVEN:TRIG ‘2 s’ !sets the trigger to run after 2 seconds
Screen/field equivalent
CAN:EVEN:TRIG sets the Trig Event field of the CDMA ANALYZER
screen.
:EVENt:TRIGger:DELay <real number>
:EVENt:TRIGger:DELay?
These commands set/query the delay value of the trigger when the
:EVEN:TRIG ‘Delay’ command is used. This command utilizes the “Real
Number Setting Syntax” on page 299, but does not use the :DUNits,
:UNITs, or :STATe commands.
Syntax
CAN:EVEN:TRIG:DEL <real number> !values from 20 µs to 10 s
CAN:EVEN:TRIG:DEL? !returns the value set
Screen/field equivalent
CAN:EVEN:TRIG:DEL controls the Trig Event field on the CDMA
ANALYZER screen when the Trig Event field is set to Delay.