Filter
Top Products
282 Chapter 1
GPIB Command Dictionary
Multiple Real Number Setting Syntax
Multiple Real Number Setting Syntax
This section defines the syntax to be used with commands that require
the Real Number Setting Syntax, but allow multiple numbers to be set
in one command.
This format is typically used for entering values that are grouped in
rows or columns.
The format is the same as for the Real Number Setting Syntax, except
that each real number is preceded by an integer that identifies the
relative position in the list of numbers.
Syntax
:Previous Syntax <integer_value>,<real_value>[display unit_of_measure]
!integer_value is the position, real_value is the actual value
:Previous Syntax? <integer_value> !returns the value of the position
:Previous Syntax:DUNits <integer_value>,<display unit_of_measure>
!sets the units
:Previous Syntax:DUNits? <integer_value> !returns the display units
:Previous Syntax:UNits <integer_value>,<GPIB unit_of_measure>
:Previous Syntax:UNits? <integer_value> !Displays the GPIB units
:Previous Syntax:INCRement <integer_value>,<incr_value>[display
unit_of_measure]
!increments the present value
:Previous Syntax:INCRement <integer_value>,UP|DOWN
:Previous Syntax:INCRement? <integer_value> !returns the incr. value
:Previous Syntax:MODe <integer_value>,LINear|LOGarithm
!sets mode of the command
:Previous Syntax:MODe? <integer_value> !returns mode (LIN or LOG)
:Previous Syntax:MULTiply <integer_value>!multiplies current setting
:Previous Syntax:DIVide <integer_value>!divides current setting by 10