Filter
Top Products
80 Chapter 1
GPIB Command Dictionary
AFG2|ENCoder subsystem
:AMPS|TACS:FILLer:STOP
This command stops the output of filler data.
To use this command, AFG2:AMPS:CHAN must be set to ‘Cntl’.
Syntax
AFG2:AMPS:FILL:STOP
Screen/field equivalent
AFG2:AMPS:FILL:STOP controls the Stop Filler field on the
SIGNALING ENCODER screen when the Mode field is set to
AMPS-TACS and the Channel field is set to Cntl.
:AMPS|TACS:FVCMessage <string>
:AMPS|TACS:FVCMessage?
These commands set/query the 7 hexadecimal characters representing
the 2 type bits and 26 information bits in the forward voice channel
(FVC) message word. All seven characters must be present (with no
blank spaces) for the message to be valid. The SAT is turned off while
the FVC message stream is sent.
This command is used with the AFG2:AMPS:CHAN ‘Voice’ command.
Syntax
AFG2:AMPS:FVCM <string>
AFG2:AMPS:FVCM?
Screen/field equivalent
AFG2:AMPS:FVCM controls the Message field on the SIGNALING
ENCODER screen when the Mode field is set to AMPS-TACS and the
Channel field is set to Voice.