Filter
Top Products
Chapter 1 67
GPIB Command Dictionary
AFG2|ENCoder subsystem
AFG2|ENCoder subsystem
:AM <real number>
:AM?
This command sets AM modulation depth if the command AFG2:DEST
‘AM’ is used first.
This command utilizes the “Real Number Setting Syntax” on page 299.
Syntax
AFG2:AM <real number>
AFG2:AM? !returns the value of the amplitude modulation
Screen/field equivalent
AFG2:AM controls the AFGen2 To field (lower subfield) on the RF
GENERATOR screen when the upper subfield is set to AM.
:BURSt <integer>
:BURSt?
These commands set/query the number of times the message data is
output. To use this function, the AFG2:SEND:MODE command must
specify ‘Burst’ first.
This command uses only the :INCR command of the “Integer Number
Setting Syntax” on page 206.
Syntax
AFG2:BURS <integer>
AFG2:BURS?
Screen/field equivalent
AFG2:BURS controls the Bursts field on the SIGNALING ENCODER
screen when the Mode field is set to DTMF, AMPS-TACS, or NAMP-NTAC.