Filter
Top Products
230 Chapter 1
GPIB Command Dictionary
MEASure subsystem
:CDANalyzer:MARKer:PHASe <meas cmnd>
:CDANalyzer:MARKer:PHASe?
IS-95 Only mode. These commands set/query the phase at the marker
on the code domain analyzer’s trace during phase measurements (see
:CDAN:MEAS on page 124).This measurement is made relative to the
value at Walsh Code 0.
This measurement utilizes the Number Measurement Syntax, but does
not use the :METer command.
Syntax
MEAS:CDAN:MARK:PHAS <meas cmd>
!See “Number Measurement Syntax” on page 283.
MEAS:CDAN:MARK:PHAS?
Example
MEAS:CDAN:MARK:PHAS?
Screen/field equivalent
MEAS:CDAN:MARK:PHAS? reads the Phse field on the Marker menu
of the CODE DOM screen when a phase measurement is selected. This
applies when the CDMA standard is set to “IS-95 Only”.