Filter
Top Products
Chapter 1 283
GPIB Command Dictionary
Number Measurement Syntax
Number Measurement Syntax
This syntax is used with measurement commands. It applies to both
real and integer values.
This syntax is typically used with subsystems like the MEASure
subsystem/
Syntax
:Previous Syntax:AUNits <GPIB units> !sets the GPIB units
:Previous Syntax:AUNits !returns the GPIB units
:Previous Syntax:AVERage[:VALue] <real_value>
!sets the number of averages
:Previous Syntax:AVERage? !returns the number of averages
:Previous Syntax:AVERage:RESet !resets the number of averages to 1
:Previous Syntax:AVERage:STATe 1|ON
:Previous Syntax:AVERage:STATe 0|OFF
:Previous Syntax:AVERage:STATe? !returns 1 or 0
:Previous Syntax:DUNits <display unit_of_measure>
!sets the disp. units
:Previous Syntax:DUNits? !returns the display units
:Previous Syntax:HLIMit[:VALue] <real_value>[<units>]
!sets the value of the High Limit for a measurement display
:Previous Syntax:HLIMit? !returns the High Limit setting
:Previous Syntax:HLIMit:DUNits <units> !display units
:Previous Syntax:HLIMit:DUNits? !returns the display units
:Previous Syntax:HLIMit:EXCeeded?
!returns 1 or 0 to indicate if the High Limit was exceeded
:Previous Syntax:HLIMit:RESet !resets the limit
:Previous Syntax:HLIMit:STATe 1|ON !sets state of the limit
:Previous Syntax:HLIMit:STATe 0|OFF !sets state of the limit
:Previous Syntax:HLIMit:STATe? !returns 1 or 0
:Previous Syntax:LLIMit[:VALue] <real_value>[<units>]
!sets the value of the Low Limit for a measurement display
:Previous Syntax:LLIMit? !returns the Low Limit setting
:Previous Syntax:LLIMit:DUNits <units> !display units
:Previous Syntax:LLIMit:DUNits? !returns the display units
:Previous Syntax:LLIMit:EXCeeded?
!returns 1 or 0 to indicate if the Low Limit was exceeded
:Previous Syntax:LLIMit:RESet !resets the limit