Filter
Top Products
180 Chapter 1
GPIB Command Dictionary
CONFigure subsystem
:SPOR10|SPORT10|SB10|SP10:MODem:CONNect:HDELay
:SPOR10|SPORT10|SB10|SP10:MODem:CONNect:HDELay?
This command sets/queries the number of seconds to wait before
attempting an origination. This applies to the delay prior to attempting
a dialback as well as the delay prior to retrying an origination as part of
the retry sequence.
Syntax
CONF:SPOR10:MOD:CONN:HDEL <integer>
CONF:SPOR10:MOD:CONN:HDEL?
Screen/field equivalent
CONF:SPOR10:MOD:CONN:HDEL controls the Hold-off Delay field
on the MODEM CONFIGURE screen when the Serial Port field is set
to Port 10.
:SPOR10|SPORT10|SB10|SP10:MODem:CONNect:RETRy
:SPOR10|SPORT10|SB10|SP10:MODem:CONNect:RETRy?
This command sets/queries the number of calls that will be tried before
an origination attempt is terminated. The total number of tries will be
the number entered in this field, plus one for the original attempt.
Syntax
CONF:SPOR10:MOD:CONN:RETR <integer>
CONF:SPOR10:MOD:CONN:RETR?
Screen/field equivalent
CONF:SPOR10:MOD:CONN:RETR controls the Retries field on the
MODEM CONFIGURE screen when the Serial Port field is set to
Port 10.
:SPOR10|SPORT10|SB10|SP10:MODem:CONFigure:UPDate
This command is used to send the modem configuration strings entered
in the CONF:SPOR10:MOD:CONF:STR1, STR2, and STR3 commands.
Syntax
CONF:SPOR10:MOD:CONF:UPD
Screen/field equivalent
CONF:SPOR10:MOD:CONF:UPD controls the Modem Configuration
field on the MODEM CONFIGURE screen when the Serial Port field
is set to Port 10.