Filter
Top Products
Chapter 1 83
GPIB Command Dictionary
AFG2|ENCoder subsystem
:AMPS|TACS:SAT:FREQuency <real number>
These commands set/query the supervisory audio tone’s frequency. This
signal is sent continuously whenever AFG2:AMPS:CHAN ‘Voice’ is
used, but is interrupted when a FVC message is sent.
This command utilizes the “Real Number Setting Syntax” on page 299
but does not use the :STATe command.
Syntax
AFG2:AMPS:SAT:FREQ
Screen/field equivalent
AFG2:AMPS:SAT:FREQ controls the SAT Freq field on the
SIGNALING ENCODER screen when the Mode field is set to
AMPS-TACS and the Channel field is set to Voice.
:AMPS|TACS:STANdard <string>
:AMPS|TACS:STANdard?
These commands set/query the radio standard for the encoder.
Syntax
AFG2:AMPS:STAN ‘AMPS’
‘TACS’
‘JTACS’
AFG2:AMPS:STAN?
Screen/field equivalent
AFG2:AMPS:STAN controls the Standard field on the SIGNALING
ENCODER screen when the Mode field is set to AMPS-TACS.