Filter
Top Products
78 Chapter 1
GPIB Command Dictionary
AFG2|ENCoder subsystem
:AMPS|TACS:DATA:LEVel <real number>
:AMPS|TACS:DATA:LEVel?
These commands set/query the data level when the AFG2:DEST ‘Audio
Out’ command is used first. The data level units are mV.
This command utilizes the “Real Number Setting Syntax” on page 299.
Syntax
AFG2:AMPS:DATA:LEV
AFG2:AMPS:DATA:LEV?
Screen/field equivalent
AFG2:AMPS:DATA:LEV controls the Data Level field when AFGen2
To field is set to Audio Out on the SIGNALING ENCODER screen
when the Mode field is set to AMPS-TACS.
:AMPS|TACS:DATA:RATE <real number>
These commands set/query the data rate of the encoded message.
This command utilizes the “Real Number Setting Syntax” on page 299
but does not use the :STATe command.
Syntax
AFG2:AMPS:DATA:RATE
Screen/field equivalent
AFG2:AMPS:DATA:RATE controls the Data Rate field on the
SIGNALING ENCODER screen when the Mode field is set to
AMPS-TACS.