Filter
Top Products
5-4
Keys
Function Keys
6. CELL CONFIG This key accesses the Cell Config screen, giving access to Base Station emulation
parameters.
See Also
Screens: Cell Config
7. END CALL This key ends a call-in-progress.
8. HI LIMIT This key is used if you want to be alerted when a measurement exceeds a specified
value.
To Set a High Limit
• Position the cursor at the measurement field of your choice.
• Press , (HI LIMIT).
• Enter the value you want the high limit to be.
• Press or a units key. A HI (or H) annunciator will appear.
If a limit is exceeded during a measurement, a beep will sound (the beeper ON/OFF
control can be found in the Configure screen) and “Measurement high limit
exceeded” will be displayed. The HI (or H) annunciator will also flash as long as the
measurement is displayed.
To Turn Off (or On) a High limit
When a limit is turned off, its value is retained but is not used.
• Press , (HI LIMIT).
• Press
9. HOLD This key is used to retain measurement results by stopping swept or continuously
updated measurements.
10. INCR ÷10 This key is used to adjust the increment value by a factor of ÷10. To display the
increment value, press .
11. INCR ×10 This key is used to adjust the increment value by a factor of ×10. To display the
increment value, press .
SHIFT
⇑
ENTER
SHIFT
⇑
ON/OFF
INCR SET
INCR SET