Filter
Top Products
8-34
Instrument BASIC
Programming and Using the TESTS Subsystem
Test Sequence as described below.
3 When finished editing sequence select to return to test screen.
a. Select either Edit Parm or Edit Spec from the test function field
to continue editing.
OR
b. If editing is complete, select and press or select
Continue to return to the Edit Proc screen, then press or select
Run to run the modified test procedure.
To add tests, select the following keys according to the labelled steps in
Figure 8-15 on page 8-34:
1 Press or select Insrt Stp to insert a step.
2 Select the test name (example TEST_09) to modify the inserted step.
3 Select a new Test name for the inserted step.
4 Press or select Delet Stp to remove steps from a procedure.
Figure 8-15 Edit Sequence Screen on the HP/Agilent 83212X
NOTE The tests you select determine the specifications that are required.
Editing Test Parameters
From the Edit Procedure screen (see Procedure Development section in this
chapter), select the following keys:
TESTS
TESTS
L2
L1
L1
L2