Filter
Top Products
8-35
Instrument BASIC
Programming and Using the TESTS Subsystem
1 and select the field Test Function at the bottom of the screen.
2 From the list of Choices in the revealed box, select Edit Parm and edit the
Test Parameters as described below.
3 When finished editing parameters select to return to test screen.
a. Select either Edit Seqn or Edit Spec from the test function field
to continue editing.
OR
b. If editing is complete, select and press or select
Continue to return to the Edit Proc screen, then press or select
Run to run the modified test procedure.
NOTE For a fuller explanation of the fields see Edit Parameter.
Figure 8-16 Edit Parameters Screen on the HP/Agilent 83212X
Select the following information according to the labelled steps in Figure 8-16 on
page 8-35:
1 Select the parameter to modify, either by scrolling with the knob or entering the
Parameter Number with the Data Keypad.
2 Select the Description Value and enter a new parameter value.
Configuring External Instruments for GPIB Control
Use the following instructions to configure the IBASIC computer to see external
instruments on the GPIB “700” bus.
TESTS
TESTS
TESTS
L2
L1