Filter
Top Products
8-28
Instrument BASIC
Programming and Using the TESTS Subsystem
Figure 8-11 The Main TESTS Subsystem Screen
TESTS Subsystem
User-Interface
Screens
The TESTS subsystem allows the user to easily modify the test subroutines,
parameters, specifications and configuration to correspond to the requirements of a
specific Radio. There are several user-interface screens that allow the user to do this.
To access any of these screens, select the Test Function field at the bottom of
the main TESTS screen to display the screen choices.
• The Edit Sequence screen lets you select the desired test(s) from the full set of
available tests in the default Procedure file.
• The Edit Specifications screen defines the specifications used to generate
pass/fail messages during testing.
• The Edit Parameters screen is used to define instrument settings and
characteristics to match those of the radio being tested (audio load impedance,
audio power, power supply voltage,..etc.).
• The Edit Configuration screen identifies all connected GPIB equipped
instruments and their GPIB addresses.
• The Procedure Manager screen is used to make or delete Procedures.