Filter
Top Products
114 ICX (International) issued October 2000 ICX-50-700
Chapter 4. User Maintenance Section 700 - Operation
To set the Verified Account code:
Action Result
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See “To enter User Maintenance mode:” on
page 79.)
81-
User MAINT displays
2. At the 81 level, enter 04.
3. Press the HOLD key. 8104-
Verified ACCD displays
4. Press the HOLD key. Table Number displays
5. Enter the Verified Account table number (001-500).
6. Press the HOLD key. XXX-
Verified ACCD displays (where XXX
= account code table number)
7. Press the HOLD key. 0001 : AAAAAAAAAAA
XXX:Account Code displays (where
AAAAAAAAAAA = current account
code and XXX = account code table
number)
8. Enter up to ten-digit Verified Account Code. (All Verified
Account Codes must be unique. If there is a matching entry
entered, the System will not accept the entry and will double
beep.)
Note: To clear an entry or existing data, press the FL/R
key.
9. Press the HOLD key. 0002 :X
XXX:TRS Class displays (where X =
TRS Class)
10. Enter the TRS (Call Barring) Class to be associated with
the Verified Account Code entry.
11. Press the HOLD key to store the entry. 0001 :YYY displays (where YYY = the
next account code table number)
12. To add additional Verified Account numbers, press the
volume up or down key or press the HOLD key to move to
the desired Verified Account table number.
Desired Verified Account table number
displays
13. Repeat steps 8-12 until all Verified Account numbers are
entered.
14. Press the MEMORY key to exit the entry mode Table Number
15. To return to the top menu level (81), press the PROG key.
OR...
To exit the User Maintenance mode, press the ON/OFF
key.
81-
User MAINT displays
OR...
ON/OFF LED goes off